CSD-709 Digital Peak Holder

Specifications

How to choose Digital indicator

Points to check when selecting, with the values for this product (CSD-709).

1. 1. Input range matching sensor output

   Confirm that the rated output (mV/V) of the strain-gauge sensor falls within the input range of the indicator. If the range is too wide, the resolution cannot be fully utilized; if too narrow, the input saturates. Check against the rated output in the load cell's calibration certificate.

2. 2. Bridge excitation and number of connected sensors

   Confirm that the excitation voltage supplied to the sensor is at or below the sensor's recommended excitation voltage. When multiple load cells are connected in parallel, the combined resistance decreases and current increases, so also check whether the indicator can supply the required load conditions.

3. 3. Sampling speed suited to the process speed

   This product: A/D sampling rate 4000 回/s

   In processes where the load changes over a short time, such as press-fitting, pressing, or punching, a slow A/D sampling rate may miss peak values. For static weighing, a low speed is sufficient. Note that this value is different from the display update rate (display refresh count).

4. 4. Required display digits and resolution

   Determine the required number of display digits from the capacity and minimum scale division, and confirm that the display range meets them. Check not only the display resolution but also whether the actual measurement accuracy, including non-linearity (0.02% F.S. for the listed products), meets the requirement.

5. 5. Mounting method and external dimensions

   This product: External dimensions 96×48×110 mm

   Confirm that the panel cutout dimensions and depth fit the panel or enclosure. Select the mounting method as well, such as DIN rail type for installation inside a control panel or board type for equipment integration. Also check the required outputs and communication options, such as CC-Link, RS-232C, or BCD, at the same time.

6. 6. Power supply type and power consumption

   Check whether AC or DC power is required, whether wide-range power input is supported, and whether battery operation is possible, according to the installation environment. Power consumption of the listed products ranges from 2.4 to 25 W, which is used for evaluating the power capacity and heat generation inside the panel.

This guide was written by AI based on the listed products' documents and specification items.

About Digital indicator and all products

Description

A/D conversion 24 bit, display range -99999 to 99999. Bridge power supply DC 10 V. USB as standard, various interfaces available as options.

FAQ

Q. What peak hold detection methods does the CSD-709 support?

A. It has 36 detection methods.

Q. What applications is the CSD-709 suitable for?

A. It can be used for press-fitting, pressing, and punching applications.

Q. What are the measurement speed and resolution of the CSD-709?

A. The A/D sampling rate is 4000 times/s and the A/D internal resolution is 24 bit. Non-linearity is 0.02 %F.S. ±1 digit.

Q. What are the bridge power supply and interfaces of the CSD-709?

A. The bridge power supply is DC 10 V. USB is provided as standard, and various interfaces can be selected as options.

Q. What are the display range, external dimensions, and mass of the CSD-709?

A. The display range is -99999 to 99999. External dimensions are 96 × 48 × 110 mm, and mass is approximately 500 g.

Written by AI based on the content of the source documents.

Source documents

• Catalog 製品ガイダンス 計測・計装用各種センサー・機器類 24 pages
  Found on: https://azuma-eg.com/catalogue/