Anchor Bolt (Internal Cone Driven Type)

Specifications

How to choose Anchors

Points to check when selecting, with the values for this product (99-0210).

1. 1. Select a matching bolt for the base material and fixture

   ALC anchors have a fixed bolt nominal diameter for each size. The listed products are grouped as M4, M5 to M6, M8, and M8 to M10. Select the type that matches the hole diameter of the bracket being fixed and the nominal diameter of the bolt you use.

2. 2. Compare required load with the tensile strength guide

   The guide tensile strength for the listed products when used with bolts is 1.8 to 3.5 kN. Select with a margin by including the weight of the fixture as well as loads from earthquakes and vibration. The values shown are guides only, and actual strength varies with the condition of the base material and installation accuracy.

3. 3. Determine the neck length from fixture thickness plus embedment depth

   The under-head length of the listed screw-in anchors is 35 to 150 mm. Choose a length equal to the thickness of the bracket or rafter being fixed plus the required screw-in depth in the concrete. If the length is insufficient, holding force will be inadequate; if it is too long, the pilot hole becomes deeper and installation takes more effort.

4. 4. Maintain the correct pilot hole diameter and depth

   The listed products require a pilot hole diameter of 10 to 14 mm and a pilot hole depth of 60 to 80 mm. If the hole is too large, biting force will be insufficient; if it is too small, the base material may crack or the anchor may not thread in. Use a bit of the specified diameter and drill to the specified depth.

5. 5. Embedment depth, body diameter, and edge distance in the base material

   ALC anchors have a total length (embedment depth) of 50 to 70 mm and a body diameter of 15 to 22 mm. Larger sizes generally achieve higher strength, but they also require greater base material thickness and edge distance. Check the thickness of the ALC panel and the distance from the edge at the installation position.

6. 6. Check the installation bit and recess

   Some types require a dedicated high-speed bit, and some have a drive recess in the head that accepts square bits. Confirm in advance that your impact driver bits fit, so that installation does not stop on site due to incompatible tools.

This guide was written by AI based on the listed products' documents and specification items.

About Anchors and all products

Description

Anchor bolt used for fixing machine mounting fittings. For M12, the part number is 99-0211. The recommended part number for the mounting fitting is indicated.

FAQ

Q. What sizes are available for the anchor bolt (internal cone driven type), part number 99-0210?

A. It is available in two sizes, M10 and M12. The part number for M12 is 99-0211.

Q. What are the overall length, drill diameter, and depth of the anchor bolt, part number 99-0210?

A. The overall length is 40 mm, the drill diameter is 12.5 mm, and the depth is 40 mm.

Q. What kind of fixing is the anchor bolt 99-0210 used for?

A. It is an anchor bolt used for fixing machine mounting fittings, and its application is floor fixing of machine mounting fittings.

Q. Is the anchor bolt 99-0210 a limited stock item?

A. Yes, it is a limited stock item.

Written by AI based on the content of the source documents.

Source documents

• Catalog スプリングネット 製品カタログ（ページ抜粋） 43 pages Open page 32
  Found on: https://www.samini.co.jp/catalog_list/